Grizzly T10446 - Manual (Page 9)

Model t10446 heavy-duty hammer drill -7 -
depth stop
Use the depth stop to halt the advance of
the bit at the desired drilling depth.
to attach the depth stop:
1. disConneCt tooL FroM poWer!
2. Loosen the auxiliary handle and slide
the depth stop into the hole on the
handle bracket (see
figure 5).
note: Make sure the bend in the depth
stop is next to the bit. This will ensure
that the gauge will contact the work
surface next to the hole being drilled.
3. adjust the gauge to the proper depth
for the operation, then secure it in place
by re-tightening the auxiliary handle.
operation
to use the hammer drill:
1. if desired, slide the dust cup onto the
bit with the cupped side facing the work
surface. install the drill bit as instructed
on the previous page.
2. adjust the depth stop for the drilling
depth desired.
3. put on the appropriate personal
protective equipment.
4. Firmly hold the drill with one hand on
the grip and the other on the auxiliary
handle, then position the tip of the bit
on the work surface with firm but not
heavy pressure.
dust and debris from hammer drill
operation can be harmful to eyes,
respiratory system, face, and skin.
also, the noise can cause hearing
loss over time. always wear heavy
work gloves and long sleeves, safe-
ty goggles and faceshield, respira-
tor, and hearing protection during
operation.
5. pull the trigger to turn the drill ON, and
begin drilling.
note: Depending on the drilling depth,
you may need to clear the bit while drill-
ing by moving the rotating bit in and out
of the hole.
6. When the hole is complete, remove the
bit from the hole while it is still rotat-
ing and release the trigger to turn the
drill
OFF. allow the bit to stop rotating
before putting the drill down.
the hammer drill produces signifi-
cant torque during operation. to
prevent injuries from loss of con-
trol, always firmly hold the grip with
one hand and the auxiliary handle
with the other before starting the
tool and during operation.
figure 5. depth stop attached.
handle
Bracket
hole