Important installation instructions, Warning – Genie 2024 User Manual

Page 9

Advertising
background image

PN# 37026500123 05/15/2009

9

OPENER ASSEMBLY

FOR HELP-1.800.354.3643 OR WWW.GENIECOMPANY.COM

1

NOTE: Three (3) piece rail assemblies are for a 7

foot high sectional door.

Clear a workspace area to unpack and organize box

and contents for assembly.
1. There are 4 boxes inside the carton. Each box is

numbered 1 - 4. Note that some openers will

contain the same parts and be packaged with

fewer boxes.

Carefully remove the three

internal boxes (Labeled #1, 2, and 3) and place

them on the floor for easy access (Fig. 1-1).

These boxes contain assembly parts and the

contents are organized by assembly tasks. For

quick reference inside the lid of each box there is

a label illustrating the components inside.

2. Remove the motor power head and place it on

the floor for later use. Remove box #4 and

place it on the floor for later use.

Do NOT run until opener is fully assembled and

instructed to do so.

CAUTION

FIG. 1-1 Internal boxes.

RAIL ASSEMBLY: Use a clean, flat surface.

Rail Connectors

Rail Connector Bolts

Rail Connector Nuts

Bolts

Power head

Rail

Lag Srews

5/16" Nuts

& Bolts

Header Bracket

Bolts

Header Bracket

Bag 2

Bag 3

Bag 1

Bag 0

Box Label Example

#4

1.

READ AND FOLLOW ALL SAFETY, INSTALLATION

AND OPERATION INSTRUCTIONS.

(If you have

questions or do not understand an instruction, call The

Genie Company or an authorized Genie

®

Dealer.)

2. Install only on a properly balanced

sectional garage door.

An improperly balanced door could cause severe injury.

Have a trained door system technician make repairs or

adjustments to cables, spring assemblies, and other

hardware

before installing the opener.

3. Remove all ropes and remove or make inoperative all

locks connected to the garage door before installing opener.

4. Where possible, install the door opener

7 feet or more

above the floor. For products having an emergency

release, mount the emergency release 6 feet above the floor.

IMPORTANT INSTALLATION INSTRUCTIONS

WARNING:

To reduce the risk of severe injury or death:

5.

Do NOT connect the opener to source of power

until instructed to do so.

6. Locate the Wall Control:

• Within sight of door,

• At minimum height of 5 feet so small children are not

able to reach it, and

• Away from all moving parts of the door.

7. Install the

Entrapment WARNING Label next to the Wall

Control in a prominent location. Install the Emergency

Release Tag on or next to the emergency release.

8. After installing the opener, the door

must reverse within

2 seconds when it contacts a 1-1/2 inch high object (or a

2 x 4 board laid flat) on the floor.

To reduce the risk of injury to persons or

damage to property - Use this opener only

with sectional doors.

WARNING

NOTE: For 1-piece rail—skip to POWER HEAD &

RAIL ASSEMBLY.

NOTE: Please follow ALL instructions in their NUMBERED sequence. Use wall control and safety sensors

provided with this unit. Do NOT substitute wall control or safety sensors.

Advertising
This manual is related to the following products: