Maytag W10445417B - Manual (Page 15)

15
3-wire receptacle (NEMA
type 10-30R)
3-prong plug
Spade terminals with
upturned ends
Ring terminals
Use where local codes permit connecting cabinet-ground
conductor to neutral wire.
3.
Connect remaining wires
2.
Connect neutral wire
D
B
3.
Connect remaining wires
1.
Remove center screw
B
Connect remaining wires under outer terminal block screws.
Tighten screws. Finally, reinsert tab of terminal block cover
into slot of dryer rear panel. Tighten strain relief nut. Now,
go to “Venting Requirements.”
Connect the other wires to outer terminal block screws.
Tighten screws. Replace the terminal block cover on the back
of the dryer. Tighten strain relief nut. Now, go to “Venting
Requirements.”
Connect neutral wire (white or center) (D) of power supply cord
under center terminal block screw (B). Tighten screw.
Remove center terminal block screw (B).
3-Wire Power Supply Cord Connection