Miller Electric 350 VS - Manual (Page 24)

OM-2251 Page 20
5-2. Meter Functions
.
The meters display the actual weld output values for approximately three seconds after the arc is broken.
Mode Meter Reading At Idle Meter Reading While Welding
Scratch
Start TIG
V A
Actual Volts (OCV) Preset Amps
71.7 85
Actual Volts Actual Amps
V A
10.3 85
Lift-Arc TIG
Actual Volts Preset Amps
V A
14.1 85
Actual Volts Actual Amps
V A
10.3 85
Stick
Actual Volts (OCV) Preset Amps
V A
71.7 85
Actual Volts Actual Amps
V A
24.5 85
V-Sense
Feeder
Flashes OCV And Preset Blank
V A
71.7
Actual Volts Actual Amps
V A
24.5 250
5-3. Mode Switch Settings
.
Stick mode provides the Adaptive Hot Start ™ feature, which automatically increases the output amperage at the start of a weld should the start
require it. This eliminates electrode sticking at arc start.
Mode Switch Setting Process Output Control Mode Switch Setting Process Output Control
Scratch Start TIG GTAW Electrode Hot
Lift-Arc TIG GTAW − See Section 5-4 Electrode Hot
Stick SMAW Electrode Hot
V-Sense Feeder MIG (GMAW) With Voltage Sensing Wire Feeder Electrode Hot