Marantz RC3001 - Manual (Page 21)

16
ENGLISH
4. This screen changes to HOME mode.
Press the button next to the displayed
device name whose commands you want
to learn.
Note:
In Home mode, learning cannot be performed with
the SOFT button using the procedure shown below.
Use the Wizz.it 3 editor to make any changes.
5. After selecting the device name, press the
button whose command you want to learn.
6. This enters the learning standby mode.
Send the remote controller code that you
want to learn.
7. The remote controller has completed
learning when LEARN OK is displayed on
the LCD.
• Pressing the ENTER button enables
you to continue learning commands
for another button in the same device
mode.
• When the learning mode is completed,
press the Home button three times to
return the LCD to the MAIN MENU.
Notes:
• If learning could not be performed, LEARN
ERROR is displayed on the LCD. Try
performing steps 5 to 6 again.
• When making the learning settings, the
LEARN ERROR message may occasionally
be displayed repeatedly on the LCD. In some
cases, this can be due to transmission of a
special remote controller signal code. Learning
cannot be performed when a special remote
controller signal code is used.
• The RC3001 can learn up to a maximum of
1,000 remote controller codes. Once 1,000 codes
are programmed for learning, LEARNFULL
is displayed on the LCD, and learning can no
longer be performed.
To perform further learning, use the Wizz.it 3
editor to delete any unneeded learning codes.