Efore – Maytag MAH7500 User Manual
Page 20
• Be sure the door is tightly closed.
• Plug cord into a live electrical outlet (tub light should illuminate).
• Check fuse or reset circuit breaker.
• Open and close the door, then push the START/PAUSE touchpad.
• Turn both faucets on fully.
• Straighten inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Open and close the door, then push the START/PAUSE touchpad.
• Check fuse or reset circuit breaker.
• Open and close the door and press the START/PAUSE touchpad. For your safety, the clothes washer
will not tumble or spin unless the door is closed.
• Press the START/PAUSE touchpad to stop the washer.
• It may take a few moments for the door lock mechanism to disengage.
• Open the door and wash the lower portion of the gray door seal with a solution of 1 cup chlorine
bleach to 2 cups water.
• Select the following control panel setting: Cotton Sturdy, Hot/Cold, Heavy soil setting.
• Fill the bleach dispenser cup with liquid chlorine bleach and start the washer.
• Pour an additional 1/2 cup bleach into the detergent dispenser as the washer is filling.
• Allow the washer to complete the cycle.
• At the end of the cycle, open the door and dry the gray door seal.
• Clothes washer should be leveled properly as outlined in installation instructions.
• Check the leveling leg lock nuts are tightened.
• Be sure rubber feet are installed on leveling legs.
• Weak floors can cause vibration and walking.
• For information on normal operating sounds, see page 20.
19
EFORE
Y
OU
C
ALL
CONT
.
C
HECK THESE POINTS IF YOUR
M
AYTAG
N
EPTUNE
®
WASHER
...
B
For further assistance, call Maytag Customer Service toll-free at 1-888-4-MAYTAG (1-888-462-9824).
U.S. customers using TTY for deaf, hearing impaired or speech impaired, call 1-800-688-2080.
Door Locked Shut;
Will Not Open
Freshening
Your Washer
Is Noisy
Won’t Fill
Won’t Tumble