Motorola 9601 - Manual (Page 36)

Maintaining the Pocket Phone
Issue 3 October 1997 A-3
■
Unplug this product from wall outlets and telephone jacks before cleaning.
Clean exposed parts with a soft, damp cloth. Do not use liquid or aerosol
cleaners.
■ Unplug this product from the wall outlet, remove the telephone line cord
from the modular wall jack or communications systems switch/control unit,
and refer servicing to qualified service personnel under the following
conditions:
— Power cord or plug is damaged or frayed
— Product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the
operating instructions because improper adjustment of other
controls may result in damage and will often require extensive work
by a qualified technician to restore the product to normal operation.
— Product has been dropped and the housing has been damaged.
■ This product should be serviced by (or taken to) a qualified service center
when service or repair work is required. Do not open the product; there are
no user serviceable components inside.
Maintaining the Pocket Phone
NOTE:
The cautions and warnings in the previous section are also applicable to this
section, as are the safety instructions.
This telephone is designed to provide trouble-free performance without any
special maintenance procedures. To reduce the risk of accidental damage, do the
following.
■
Keep the telephone in an area free of dust, smoke, and moisture.
■
Do not place the telephone near a heating duct, radiator, or other heat
source, and do not drop or expose it to excessive shock or vibration.
■ Unplug the battery charger if its power cord is damaged, if liquid is spilled
into it, or if its housing becomes cracked or otherwise damaged.
■ To clean the telephone, wipe the outside housing with a soft, dust-free
cloth. If absolutely necessary, you may use a cloth slightly dampened with
a mild soap and water solution. Dry the phone quickly with a soft cloth.
!
CAUTION:
Your telephone contains sensitive electronic parts. Never submerge it in any
kind of liquid, and never use detergents, alcohols, solvents, abrasive
cleaners, or an excessive amount of water when cleaning the housing and
faceplate. To do so could result in irreparable damage.