Marantz RC1200 - Manual (Page 37)

ENGLISH
MEMO CLEAR GUIDE MUTE
CH VOL
OK
1 2 3 4 5
C D DVD CD-R/MD
DSS T V VCR
AMP L D TUNER TAPE
AUX
AUTO DOLBY THX DTS HALL
OK
MEMO
w
q
OTHER FUNCTIONS
LIGHTING BUTTON
To allow easy use in a location which has been
darkened for a home theater performance, for
instance, this remote controller has an LCD display
which lights up. It lights up when the
LIGHTING
button ⁄9 or any other button is pressed. While the
LIGHTING button ⁄9 is pressed, it lights, and when
it is released, it goes off.
• S i g n a l s c a n b e s e n t e v e n w h i l e t h e
LIGHTING button is held down.
• The display can be set to light for a duration
of 0 to 10 seconds.
Note:
• When the lighting duration is set to 0,
the LCD display will light up only while
the
LIGHTING button ⁄9 is held down
and for 5 seconds after the button is
released.
LUMINOUS BUTTONS
The buttons on this remote controller are
designed to remain luminous in dim lighting
conditions. If the buttons are no longer
luminous when the remote controller is used in
low light, recharge them by placing it near a
fluorescent or other light source for a sufficient
amount of time. This should return the buttons
to their luminous condition.
SETUP
Switch the RC-5 destination or adjust the time
interval between transmissions of macro
operations as follows:
1. While pressing the MEMO button ⁄6 ,
press the OK Cursor button ⁄0. This will
switch the remote controller to the Setup
mode.
(Wait 3 seconds.)