Configuring the board and ports – Moxa Technologies CP-168U User Manual
Page 55
Software
Installation
Smartio CP-168U User’s Manual 3-39
Once the board and the driver are installed and the driver restarts successfully, you can start
to develop applications with the PComm library (see “Serial Programming Tools”) or the
Microsoft Win32 API. You can also use applications such as Terminal Emulator (see
“Serial Programming Tools”), a PComm utility, or HyperTerminal, to transmit/receive data,
as well as Remote Access Service to provide dial-up networking capabilities.
Configuring the Board and Ports
Re-Configuring Port Settings
If the driver is already installed, and you only wish to re-configure the ports, refer to the
following procedures. In addition to the procedures listed below, you may also click on
[Start] " [Programs] " [MOXA Utility] " [MOXA Smartio/Industio Configuration Panel]
" [Property], and then refer to the instructions in the previous section, “First Time Driver
Installation.”
1. Open the [Control Panel], click on the [Network] icon, and select the [Adapters] tab.
2. Click on MOXA Smartio/Industio Family Adapter from the Network Adapters list to
highlight it, and then click on [Properties] to open the MOXA Smartio/Industio
Configuration Panel dialog box to change port settings and advanced FIFO
configuration.