MACKIE Pro Audio Lab - Manual (Page 33)

User’s Guide
Using an Aux Send with a Plug-in
• Click the associated Input Source button and select an Aux input source. In
the example below, we have chosen the Aux 4 Bus.
Send the Input Signal to the Aux Bus
1. Send a signal to a D8B mixer input channel (MIC/LINE or TAPE IN).
2. Assign the input channel V-Pot/GUI Control Pot to an aux send. We have
chosen AUX 4 according to the example above.
3. Use the AUX 4 control to adjust the input level to the plug-in.
Remember: Select an aux send before using the V-pot or GUI Control Pot on the mixer
input channel (MIC/LINE or TAPE IN).
You will see the plug-in’s input meter become active as you raise the mixer input
channel’s aux send.
Set the plug-in input/output signal levels as you would with any effect, so the meter
reaches its upper-most range every so often (always trust your ears fi rst). This can
be accomplished from the console or GUI.
GUI Control
Pot As signed
to AUX 4