Motorola 2200 - Manual (Page 225)

225
802.1p priority bit field for tagged IP packets transmitted from this por t for this VLAN. All mappings
between Ethernet 802.1p and IP-TOS are made via
diffserv dscp-map settings.
set vlan name name ports port port-pbits [ 0 - 7 ]
Specifies the 802.1p priority bit for this por t associated with the specified VLAN. If you set this to a
value greater than 0, all packets of this por t with unmarked priority bits (pbits) will be re-marked to this
priority.
set vlan name name ip-interface ip_interface
Associates this VLAN with the specified IP inter face. By default the ip-vcc1 and ip-eth-a inter faces are
available, but others may be defined.
set vlan name name inter-vlan-routing [ group-1... group-8 ] [ off | on ]
When set to on, inter-vlan-routing allows VLANs in the specified group to route traffic to the others;
ungrouped VLANs cannot route traffic to each other.
You must save the changes, exit out of configuration mode, and restar t the Gateway for the changes to
take effect.
Example 1:
❑ A simple example using the “Step” method – Navigate to the VLAN item:
Netopia-3000/9437188 (top)>> vlan
Netopia-3000/9437188 (vlan)>> set
vlan
(vlan) node list ...
Select (name) node to modify from list,
or enter new (name) to create.
vlan name (?): vlan1
(vlan1) has been added to the (vlan) list
name "vlan1"
type (by-port) [ by-port | global ]: by-port
admin-restricted (off) [ off | on ]: off
seg-pbits (0) [ 0 - 7 ]: 0
ports
❑ At this point you have created a VLAN. It is called vlan1, without any admin restrictions.
❑ Next, add the port eth0.1 port to this VLAN:
ports
eth0.1
option (off) [ off | on ]: on
priority (off) [ off | on ]: on
promote (off) [ off | on ]: on
port-pbits (0) [ 0 - 7 ]: 1
eth0.2
option (off) [ off | on ]:
eth0.3
option (off) [ off | on ]:
eth0.4
option (off) [ off | on ]:
ssid1
option (off) [ off | on ]:
vcc1
option (off) [ off | on ]: