Marantz SA-11S1 - Manual (Page 10)

6
ENGLISH
REAR PANEL
A ANALOG OUTPUTS UNBALANCED connectors
These are the unbalanced output jacks of the analog
audio signals. The supplied analog connection cord
can be connected to the CD, AUX, or other
connectors on an amplifier. Be sure to connect the L
and R channels correctly to the corresponding jacks.
* Never connect to the PHONO connector on the
amplifier.
B ANALOG OUTPUTS BALANCED connectors
These are the balanced output jacks of the analog
audio signals. A balanced connection cord (available
commercially) can be connected to the balanced
input jack of the amplifier. Be sure to connect the L
and R channels correctly to the corresponding jack.
(See page 13)
* If connecting the balanced output jacks, be sure to
leave the unbalanced jacks unconnected. (The
balanced and unbalanced connectors cannot be
used at the same time.)
C DIGITAL AUDIO OUT COAX.
It outputs the playing Audio CD signal in digital format.
This jack is to be connected with a recording device,
amplifier, D/A converter, etc that has coaxial digital
input using an optional coaxial digital cable.
* Nothing is output when digital output is set to off.
* No signal will be output when a Super Audio CD is
played.
D DIGITAL AUDIO OUT OPT.
It outputs the playing Audio CD signal in digital format.
This jack is to be connected with a recording device,
amplifier, D/A converter, etc that has optical digital
input using an optional square type optical digital
cable.
* Nothing is output when digital output is set to off.
* No signal will be output when a Super Audio CD is
played.
E REMOTE CONTROL IN, OUT (input and
output) connectors
When the remote control connectors on the player
and on a Marantz AV component are connected using
the accessory remote control connecting cables, the
components can be operated as a system by remote
control.
• When connecting to a component which is
equipped with remote control connectors, the
player’s REMOTE CONTROL IN connector must
always be connected to the REMOTE CONTROL
OUT connector on the other component to be
connected.
• When connecting a component which is not
equipped with an infrared remote sensor, this
component must always be connected to the
player’s REMOTE CONTROL OUT connector.
F EXT./INT. (Ext./Internal switch)
When this unit is used as a standalone component,
set this switch to the INT. side. When it is used
connected to external component by a remote
connecting cable and to audio component with a
remote sensor that supports remote controls by
Maranz, set this switch to the EXT. side.
* If the unit is used as standalone and the switch
is set to EXT. position, remote control unit
cannot be used.
G AC POWER INPUT JACK
Connect the supplied power cord to this jack and a
household AC power outlet.
) * + , - . /
04.8.3, 4:42 AM Page 6