MITSUBISHI ELECTRIC 737 - Manual (Page 10)

10 1. Basic Setup and Operation
Setting Up Other Inputs
Connect your devices to the TV, making note of
1.
which TV input jack is used for each device. See
“TV Connections,” page 14, for recommendations.
Power on the devices to ensure detection.
2.
Power on the TV. 3.
The TV will display the New Device Found screen
for each new connection it detects Learn more
about Auto Input/Auto Output Sensing on the
opposite page.
Select the device type if the device is not recog-
4.
nized automatically.
Sample New Device
Found screen.
Important Note for NetCommand IR Users
837 Series. Be sure to select the correct device
type here. Although you can change the device type
later in the
Inputs > Name menu, any “learned” Net-
Command IR codes will be erased when you make
the change.
837 Series. 5.
You can perform NetCommand IR
“learning” after selecting the device type or at a
later time when convenient. To perform now, high-
light
NetCommand and press ENTER. See “Initial
NetCommand Setup,” page 47 or “Setting Up A/V
Receiver Control,” page 52.
Press
6. BACK to close the New Device Found screen.
The TV will then display the New Device Found
screen for the next connection it finds.
Using the ANT (Antenna) Input
If using an antenna or direct cable service (no cable
box), connect the incoming coaxial cable to the TV’s
ANT input. Refer to page 18.
You must save channels to memory with a channel scan
to enable reception of all available high-definition and
standard-definition digital channels. The channel scan
will search for channels available locally. If you skip this
step, the TV will receive only analog channels.
Memorizing Channels with Channel Scan
For the ANT input
To start channel memorization
Power on the TV. 1.
Press
2. MENU and open the Initial > Channel menu.
Start channel memorization from the Initial > Channel
menu.
Press
3. ENTER to enter the menu.
Select
4. Ant Air if connected to an
over-the-air antenna. Select Ant
Cable for direct cable.
Highlight
5. Scan and press ENTER.
Channel memorization may take up
to 15 minutes to complete.
To stop channel memorization before completion,
press CANCEL.
Use the Initial > Channel > Edit menu (page 39) for
additional channel options, such as adding or deleting
channels from memory.
Setting Up TV Inputs