Minicom Advanced Systems Minicom Supervisor Phantom - Manual (Page 20)

Auto numbering – F12
3-6
Auto numbering – F12
Auto numbering gives each Phantom Remote a sequential ID number. Auto numbering is done through the
Management OSD.
For Auto numbering to work properly ALL connected computers MUST be switched on
To perform Auto numbering:
1. From the OSD Select computer window Press F7. The Enter Password box appears. See Figure 3-8.
Figure 3-8 The Enter Password box
2. Type the Administrators password (default password is ADMIN) and press Enter. The Password
window appears.
Figure 3-9 The Password window
3. Press F12 to activate Auto numbering. A Confirmation label appears.
4. Press Y to confirm. The process activates. Wait until the process is complete.
5. Press Esc to save and return to the Select Computer window. The Remote computers appear on the OSD.
See Figure 3-10.
Figure 3-10