Motorola SYMBOL LS9203 - Manual (Page 179)

Wand Emulation Interface 8-11
Convert All Bar Codes to Code 39
By default, the Wand Emulation Interface sends data to the attached host in the same symbology that was decoded. This may present
a problem for customers with legacy systems that do not recognize some newer symbologies (for example, RSS).
Enabling this parameter ignores the original symbology that was decoded, and outputs the data as if it were a Code 39 barcode. Any
lowercase characters that were in the original data stream are transmitted as uppercase characters. This also allows ADF Formatting
to occur.
If Ignore Unknown Characters is enabled, any characters that do not have a corresponding character in the Code 39 symbology set
are replaced by a space.
If Ignore Unknown Characters is disabled, if any characters that do not have a corresponding character are encountered, the scanner
emits an error beep and no data is transmitted.
ADF Note: By default, the Wand Emulation Interface does not allow scanned data to be processed by ADF rules. Enabling this
parameter has the side effect of allowing the scanned data to be processed by the ADF rules (See Chapter 13).
Enable Convert to Code 39 for Wand Host
*
Disable Convert to Code 39 for Wand Host