Maytag W10117890A - Manual (Page 13)

13
Secure the Drain Hose
1. Remove the shipping material from the power cord. Drape the power cord over the
console.
2. Remove any cardboard used to move washer.
3. Wrap the drain hose to the laundry tub leg, drain standpipe or inlet hoses, with the beaded
tie strap. Push fastener into the nearest hole in the beaded tie strap. See view A or B.
If the washer faucets and the drain standpipe are recessed, put the formed end of the drain
hose into the standpipe. Tightly wrap the tie strap around the water inlet hoses and the
drain hose. See view C.
Complete Installation
1. Check the electrical requirements. Be sure that you have the correct electrical supply and
the recommended grounding method. See “Electrical Requirements.”
2. Check that all parts are now installed. If there is an extra part, go back through the steps to
see which step was skipped.
3. Check that you have all of your tools.
4. Check that the yellow shipping materials were completely removed from the lower back
of the washer.
5. Dispose of/recycle all packaging materials.
6. Check that the water faucets are on.
7. Check for leaks around faucets and inlet hoses.
8. Plug into a grounded 3 prong outlet.
9. Remove the protective film on the console and any tape remaining on the washer.
10. Read “Washer Use.”
11. To test and to clean your washer, measure
¹⁄₂ of the normal recommended amount of
powdered or liquid detergent and pour it into the washer basket or detergent dispenser
(on some models). Close the lid. Select any cycle, and then pull the cycle control knob
out to start the washer. Allow it to complete one whole cycle.
Beaded tie strap
C B A
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING