Front panel, Status leds, Figure 6: canopy t1/e1 multiplexer front panel – Motorola T1/E1 User Manual
Page 14: Table 3: led status indicator descriptions, Figure 6
Canopy T1/E1 Multiplexer
September 2004
T1/E1 Multiplexer FPGA Version 3.4
Page 14 of 73
1.2.5 Front Panel
The control port and indicator LEDs are located on the front panel of the unit.
Figure 6: Canopy T1/E1 Multiplexer front panel
Status LEDS
The status indicator LEDS on the front of the Canopy T1/E1 Multiplexer are listed in
Table 3: LED status indicator descriptions
LED
LED indicator descriptions
PWR
ON when main power supply is OK; OFF when a malfunction is
detected
RDY
ON when self-test is successfully completed; OFF during self-test; and
BLINKING when self-test fails
CANOPY LINK
OFF when line is not active; ON when Canopy BH Ethernet line is OK
CANOPY ACT
OFF when no activity; BLINKNG when frames are being transmitted or
received on the line
LAN LINK
OFF when line is not active; ON when line is OK
Issue 3