Millennium Enterprises Integrated Modeling Amplifier - Manual (Page 24)

Getting Sounds
It never fails, there always seems to be a sound man at the back of the room, or an engineer in the control room that wants “more of this, or
less of that” (bottom line: your ear is king). But, to accommodate these situations, you may need to make some minor adjusting here and there
along the way. So here are some helpful guidelines for getting great sounds, while keeping everyone happy.
Input and Master Output Adjustments
The best setting for the input control is to use the <Input level> knob so you are occasionally lighting the clip LED. As far as setting the
Master output level, let your ears be the judge. But, if you can’t hear the rest of the band, chances are that you need to back off on the Master
volume level of the Millennium.
Amplifier settings
Gain Adjustments
To adjust the gain in the Amplifier modeling section, either turn the <Gain> knob on the front panel or press the <Edit> button to put
you in edit mode. Now use the <Preset/Effect> wheel to scroll to the amplifier model. From this point, turn the <Mix/Page> knob to
move to Page 2 of the amplifier module. The number of different amp tones are almost unlimited when making gain adjustments. Your gain
settings range from 0.0 to 10, so this gives you plenty of room for great tones in between. Note that the gain parameter will add distortion
gain when a distorted amplifier module is used and will add volume when a clean tone amplifier model is used. Always remember to save
any changes.
EQ and Preset Level
Adjusting the EQ is as easy as grabbing the knob and turning. The <Treble> controls the level of the High frequencies. The <Mid> knob
controls the level of the mid range frequencies, and the <Bass> knob controls the bass frequencies. In Preset mode, the level of each
frequency band is displayed in the 7 segment displays located above each knob. EQ settings range from 0.0 to 10. The Millennium also gives
you the ability to adjust individual preset levels by simply turning the <Level> knob to the desired setting. Always remember to save any
changes.
Note: Changes to the Gain, EQ and Level settings can be done using either the tone controls (located on the left side of the front panel) or the
<1,2,3 and 4> knobs located directly below the display. Using either editing method will correspond in the display. A sample setting is shown
below with Channel B being the active channel.
This example setting has been set from Preset mode using Channel B. Once the Millennium is in Edit mode the display will correspond.
Gain Treble Mid Bass Level
Section - 2 Setting Up Johnson Millennium
User Guide
16