IBM HOTS - Manual (Page 6)

All
indicates to use all record ordinal numbers defined (i.e. 0x00-0x13). This parameter cannot be
specified with the FILEADDR parameter.
FCt
specifies functional test mode.
NOFCt
specifies system test mode.
Help
displays the correct syntax of the command.
Examples
The following example will set the flag to run the snippets with ordinal 0 on I-stream two:
ZTEST 2 HOTS SET SNIPPETS
The following example will set the flags for not running the snippets with all ordinals on
I-stream three:
ZTEST 3 HOTS SET NORMAL ALL
The following example will set the flag for running one snippet with ordinal 0 on I-stream four:
ZTEST 4 HOTS SET NOSNIPPETS
The following example will set state 2 for ordinal 2 on I-stream one using 64 bit HOTS driver:
ZTEST HS64 SET STATE-2 O-2
The following example will set Service 8 running the Functional Test mode:
ZTEST HOTS SET SERVICE-8 FCT
Source code information
The HOTX driver suite consists of the following program segments:
Header Files
None.
Macros
This macro will be invoked at the start of both segments QHT0 and
QHT1, and will then set up all the equates and constants that these
segments will use. hotreq.mac
Description Macro
Last Updated 6/5/2006
6 HOTX Driver User's Guide © Copyright IBM Corp. 2006