Invacare 75 - Manual (Page 3)

3 Part No. 1089640 SHOWER CHAIRS
ATTACHING THE LEGS TO THE SEAT
NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY of this instruction sheet.
WITHOUT BACK (FIGURE 3)
1. Place seat upside down on a flat surface.
2. Align seat legs with seat.
3. Loosely install the four (4) mounting screws through the seat legs and into seat.
4. Once all components are assembled, tighten all hardware until a resistance is felt and all
slack is removed. Continue to tighten 1/4 to 1/2 of a turn to securely fasten.
5. For Model 75, refer to ADJUSTING THE LEG EXTENSIONS - MODEL NOS. 75 AND 85
in this instruction sheet.
FIGURE 3 - ATTACHING THE LEGS TO THE SEAT - WITHOUT BACK
Seat
Mounting Screws
Seat Legs
WITH BACK (FIGURE 4)
1. Place seat upside down on ground/floor.
2. Align seat legs with seat.
3. Align back support tubes above the seat legs as shown in FIGURE 4.
4. Loosely install the four (4) mounting screws through the back support tubes, seat legs and
into seat.
5. Once all components are assembled, tighten all hardware until a resistance is felt and all
slack is removed. Continue to tighten 1/4 to 1/2 of a turn to securely fasten.
6. For Model 85, refer to ADJUSTING THE LEG EXTENSIONS - MODEL NOS. 75 AND 85
in this instruction sheet.