Trouble shooting – Iiyama PROLITE T1530S User Manual
Page 21
ENGLISH
TROUBLE SHOOTING
If the monitor fails to operate correctly, please follow the steps below for a possible solution.
Perform the adjustments described in OPERATING THE MONITOR, depending on the problem you
have. If the monitor does not get a picture, skip to 2.
2. Consult the following items if you cannot find an appropriate adjustment item in OPERATING THE
MONITOR or if the problem persists.
If you are experiencing a problem which is not described below or you cannot correct the
problem, discontinue using the monitor and contact your dealer or iiyama service center for
further assistance.
3.
Problem
Check
The picture does
not appear.
(Power indicator
does not light up.)
The Power Cable is firmly seated in the socket.
The AC socket is live. Please check with another piece of equipment.
If the blank screen saver is in active mode, touch the keyboard or the
mouse.
Increase the Contrast and/or Back Light level.
The computer is ON.
The Signal Cable is properly connected.
The Power Switch is turned ON.
A
(Power indicator
is green.)
The signal timing of the computer is within the specification of the monitor.
(Power indicator
is orange.)
The computer is ON.
The Signal Cable is properly connected.
If the monitor is in power management mode, touch the keyboard or the
mouse.
The screen is not
synchronized.
The Signal Cable is properly connected.
The signal timing of the computer is within the specification of the monitor.
B
The signal timing of the computer is within the specification of the monitor.
The video output level of the computer is within the specification of the
monitor.
The screen
position is not in
the center.
The signal timing of the computer is within the specification of the monitor.
The screen is
too bright or too
dark.
The screen is
shaking.
C
D
E
The video output level of the computer is within the specification of the
monitor.
The power voltage is within the specification of the monitor.
The signal timing of the computer is within the specification of the monitor.
1.
F
The RS-232C Cable or the USB Cable is firmly seated in the socket.
Touch screen driver software is installed.
The touch
screen shows
no response.
G
The calibration function set up correctly.
The touch
position does not
deviate.
TROUBLE SHOOTING 18