Invacare XtraTM 1026793 - Manual (Page 41)

SECTION 6—SEAT
Part No 1026793 41 Xtra™
Installing Clothing Guards
NOTE: For this procedure, refer to FIGURE 6.5.
1. Position the threaded and unthreaded half clamps on inside and outside of the
wheelchair frame.
NOTE: Make sure the threaded half clamp is on
the outside of the wheelchair frame.
2. Loosely install the washer and socket
screw into the unthreaded and
threaded half clamps.
3. Determine the desired rigid clothing
guard position and securely tighten the
two (2) half clamps together with the
socket screw.
4. Insert the rigid clothing guard into the
slot on the threaded half clamp.
5. Repeat STEPS 1-4 for the opposite rigid
side guard.
FIGURE 6.5 Installing Clothing Guards
Half Clamp
Wheelchair
Frame
Socket Screw
Washer
Threaded Half Clamp
Slot
Rigid Clothing
Guard