Insignia NS-1DVDR - Manual (Page 26)

24
www.insignia-products.com
Maintaining
Care and handling of discs
Handling discs
Do not touch the playback side of the disc. Hold
the disc by the edges so that fingerprints do not
get on the surface. Never stick paper or tape on
the disc.
Storing discs
After playing, store the disc in its case. Do not
expose the disc to direct sunlight or sources of
heat and never leave it in a parked car exposed
to direct sunlight.
Cleaning discs
Fingerprints and dust on the disc can cause
poor picture quality and sound distortion. Before
playing, clean the disc with a clean cloth. Wipe
the disc from the center out.
Do not use strong solvents such as alcohol,
benzine, thinner, commercially available
cleaners, or anti-static spray intended for older
vinyl records.
Resetting your recorder
Reset your recorder if you observe any of the
following symptoms:
•
When your recorder is plugged in, but the
power will not turn on or off.
• When the display window does not working.
• When your recorder does not operate
normally.
To reset your recorder:
•
Press and hold the POWER button for more
than five seconds. This forces your recorder
to turn off. Press the POWER button again to
turn your recorder back on.
Or, unplug the power cord and then plug the
power cord again after more than five
seconds.
The remote
control does
not work
correctly There is an obstacle
in the path of the
remote control and
your recorder. Remove the obstacle.
The batteries in the
remote control are
exhausted. Replace the batteries with
new ones.
The remote control is
not pointed at the
remote sensor of
your recorder. Point the remote control at
the remote sensor of your
recorder.
The remote control is
too far from your
recorder. Operate the remote control
within 23 ft (7 m).
Timer
recording is
not possible The recorder clock is
not set to the correct
time. Set the clock to the correct
time.
The timer has been
programmed
incorrectly. Reprogram the timer.
The TIMER Record
indicator light does
not appear after
programming the
timer. Reprogram the Timer and
turn off your recorder to
enable the timer.
Cannot play
disc a
recorded on
your
recorder on
another
DVD player The disc was
recorded in Video
mode. Finalize the disc. See “Disc
Settings” on page 12.
Some players will not
play even a finalized
disc recorded in
Video mode. No solution.
The disc was
recorded in VR mode. The other player must be RW
compatible in order to play
the disc.
Discs recorded with
copy-once material
cannot be played on
other players. No solution.
Cannot
record or
did not
record
successfully Not enough blank
space remaining on
the disc. Use another disc.
The source you are
trying to record is
copy-protected. You cannot record the
source.
When recording to a
Video mode disc,
programs that are
copy-once protected
cannot be recorded. Use a VR mode formatted
disc for copy-once material.
Note
Never operate this product immediately after
moving it from a cold location to a warm
location. Leave it for two or three hours
without operating it. If you use this product in
such a situation, it may damage discs or
internal parts.