JVC HR-DVS3U - Manual (Page 61)

Masterpage:Right-NoTitle0
EN
61
Filename [DVS3U_3-EN.fm]
Page 61 January 10, 2002 10:43 am
A
Make connections.
Connect an audio component to the AUDIO L + R input
connectors on the VCR’s front panel.
● When connecting a monaural audio component, use only the
VCR’s AUDIO L input connector.
B
Load a cassette.
For the VHS deck
Insert a VHS (or S-VHS) cassette with the record safety
tab intact, or cover the hole using adhesive tape.
For the DV deck
Insert a Mini DV cassette with the erase protection switch
set to “REC”.
C
Set the VCR’s input mode.
Press AUX (number key “0”) and/or CH +/– to select
“F-1”.
D
Select the recording deck.
Press S-VHS or DV.
● When using the DV deck as the recording deck, press so
that the audio signals from the AUDIO L + R input connectors
can be recorded. The dubbing direction indicator (
S-VHS)
lights.
E
Locate the start point.
Press PLAY (
4
) to start playback of the tape in your VCR,
and press PAUSE (
9
) when you reach the point where
you want to start dubbing.
F
Engage the Audio Dubbing mode.
Press A.DUB.
● Your VCR enters the Audio Dubbing Pause mode. (“
o ” blinks,
“ u ” and “ i ” light up on the front display panel.)
G
Start dubbing.
Engage the audio component’s Play mode, then press
PLAY (
4
) to start the tape in your VCR; Audio Dubbing
begins at this point.
● “
o ” blinks and “ u ” is displayed on the front display panel.
● To stop dubbing temporarily, press PAUSE (
9 ). Press PLAY ( 4 )
to resume dubbing.
H
End Audio Dubbing.
Press STOP (
8
) to stop the tape in your VCR, and engage
the audio component’s Stop mode.
NOTES:
● Once the Audio Dubbing starts, you can not use the other
deck.
● When monitoring the audio-dubbed sound on the DV deck,
set “12BIT MODE” to “SOUND2” (
੬
pg. 76).
● When monitoring the sound during Audio Dubbing, the
normal soundtrack is automatically selected. If you wish to
hear the mixed sound (Hi-Fi + Normal soundtracks), press
A. MONITOR to select “NORM HI FI” (
੬
pg. 31). (VHS
deck only)
● Audio Dubbing stops automatically when the counter reaches
“0:00:00”, and the VCR enters the Play mode. Check the
counter reading before dubbing. (VHS deck only)
● Audio Dubbing is also possible using the rear panel AUDIO IN
connector.
● When playing back an audio-dubbed tape on the VHS deck,
press A. MONITOR on the Remote to select the soundtrack
you wish to hear (
੬
pg. 31). When playing back an audio-
dubbed Mini DV tape on the DV deck, set “12BIT MODE” to
“SOUND2” (
੬
pg. 76).
● Picture may be distorted during Audio Dubbing Pause.
● It may be unlawful to record or play back copyrighted material
without the consent of the copyright owner.
● Audio dubbing is not possible using the DV IN/OUT
connector.
● Audio dubbing is not possible on a blank portion of the tape.
DVS3U_1-EN.book Page 61 Thursday, January 10, 2002 10:51 AM