JVC XV-THD51 - Manual (Page 27)

24
SPK.SETTING menu is available only when the speaker position mode is set to “S.SPK R” ( 11).
Audio menu (AUDIO)
DOWN MIX This menu is available only when the speaker position mode is set to “S.SPK F” ( 11).
Select the audio signal output to the TV connected to the HDMI MONITOR OUT terminal.
DOLBY SURROUND: For the TV equipped with Dolby Pro Logic decoder
STEREO: For ordinary TV
D. RANGE
COMPRESSION You can enjoy powerful audio even at low volume level while playing Dolby Digital software.
AUTO: Select this to apply the compression only to the multi-channel software (except 1-
channel and 2-channel sources).
ON: Select this to always apply the compression.
HDMI AUDIO OUT This setting is effective only for the source “DVD” or “USB.”
Select whether the System emits the audio signal from the HDMI MONITOR OUT terminal (ON)
or not (OFF).
Other setting menu (OTHERS)
RESUME Activate (ON) or deactivate (OFF) the resume function.
ON SCREEN GUIDE Activate (ON) or deactivate (OFF) the on-screen guide icons.
DivX REGISTRATION The System has its own Registration Code for DivX playback. You can confirm the code of
your System.
• Once you play back a DivX file created by using the Registration Code, the System’s code
is overwritten by a totally different new one for copyright protection purposes.
Speaker setting menu (SPK.SETTING)
LEVEL Adjust the output level of each speaker while monitoring the test tone.
FRONT LEFT/RIGHT SPEAKER, CENTER SPEAKER, SURROUND RIGHT/LEFT
SPEAKER: Select the speaker, then adjust the output level.
TEST TONE: Turns on/off the test tone.
DELAY Adjust the delay time of the speakers.
FRONT LEFT/RIGHT SPEAKER,
CENTER SPEAKER, SURROUND
RIGHT/LEFT SPEAKER: Select the
speaker, then adjust the distance from
the listening position to the speakers.
• 1 ms increase (or decrease) in delay time
corresponds to about 30 cm decrease (or
increase) in distance.
• Set to 0 ms for the furthest speaker from
your position as the basis for the delay time
setting.
SUBWOOFER Make the subwoofer setting.
LEVEL: Adjust the output level of the subwoofer.
CROSS OVER: Select an appropriate crossover frequency according to the size of the
cone speaker unit built into the small speaker connected.
120Hz: Select this when the cone speaker unit size is 8 cm or more.
150Hz: Select this when the cone speaker unit size is between 6 cm and 8 cm.
200Hz: Select this when the cone speaker unit size is 5 cm or less.
Front left
0 ms
Center
1 ms
Ex.: Subwoofer
Surround right
2 ms
Front right
0 ms
2.1 m
2.4 m
2.7 m
3.0 m
Surround left
2 ms
Underlined items are the
initial settings.
TH-D51[B]EN.book Page 24 Friday, August 3, 2007 10:26 AM