JVC HR-J633U - Manual (Page 10)

10
1 2
4 5
3
6
8
0
7 9
SELECT D.S.T. MODE
6
You have three choices:
a–Select “AUTO” and the
adjustment to your VCR’s
clock will be made
according to the incoming
signal from the host
channel.
b–Select “ON” and the
adjustment will be made
based on the clock itself.
c–Select “OFF” if Daylight Saving Time doesn’t apply to
you.
Place the arrow next to your choice by pressing
CH
5∞ or SHUTTLE PLUS 5∞, then press MENU and
the Semi-Auto Clock Set screen reappears.
D.S.T. SELECT
=AUTO
ON
OFF
PRESS ( 5,∞) TO SELECT
PRESS (MENU) TO END
2 2
q 5 / 8 6
CH
MENU
OK
CH
OK
MENU
NUMBER
INITIAL SETTINGS (cont.)
SHUTTLE PLUS
IMPORTANT
After performing the Semi-Auto clock set procedure, make
sure that the VCR is off before the next hour so that the clock
can be set. (The clock is automatically adjusted on the hour
except at 11:00 PM, midnight, 1:00 AM and 2:00 AM.)
Manual
SELECT MODE
2
At the Override Auto Clock Set screen, place the
arrow next to “MANUAL CLOCK SET” by pressing
CH▲▼ or SHUTTLE PLUS
5∞, then press OK.
SET DATE, TIME AND D.S.T.
3
The Manual Clock Set
screen is displayed and the
first setting that can be set
begins flashing.
Press the appropriate
NUMBER keys to set the
date and time (if only 1
digit, press "0" first). Press
CH▲▼ or SHUTTLE PLUS
5∞ to set AM/PM and D.S.T. (Daylight Saving Time) to
“ON” (automatic adjustment based on VCR’s clock) or
“OFF” (if D.S.T. doesn’t apply to you).
Press OK after AM/PM and D.S.T. settings. The next
setting that can be set begins flashing. When you’re
finished with this set-up procedure, press MENU to start
the clock.
NOTE:
CH 5∞ and SHUTTLE PLUS 5∞ can be used to perform
all operations. (In this case, press OK after each setting.)
MAKE CORRECTIONS
4
To change any of the settings, press OK or SHUTTLE
PLUS ™ £ until the item you want to change
blinks, then set as in step 3.
MANUAL CLOCK SET
DATE 1/ 1/96 MON
TIME – – : – – AM
D.S.T. ON
PRESS NUMBER KEY(0-9)
OR ( 5,∞), THEN (OK)
PRESS (MENU) TO END