JVC HR-J658E - Manual (Page 39)

EN
39
%
PERFORM AUTO CHANNEL
SET
6
Press OK or .
● The Auto Set screen
appears, and remains
on screen while the
recorder searches for
receivable stations.
As Auto Channel
Set progresses, the
" " mark on the
screen moves from
left to right.
Wait until the screen as shown in step 7 appears.
VIEW CONFIRMATION
SCREEN
7
After "SCAN COMPLETED"
is displayed on the screen
for about 5 seconds, the
Confirmation screen
looking like the one to the
right appears. The stations
your recorder located
appear on a Confirmation
screen — channel
positions (PR), channels
(CH) and station names
(ID –
੬
pg. 43). The blueback screen and the
programme currently being broadcast by the blinking
station appear alternately for 8 seconds each.
To view the next page, use the
%fi button on the
remote control.
● The stations located in the selected country appear at
the top of the list.
● The Guide Program numbers will also be set
automatically during Auto Channel Set.
RETURN TO NORMAL
SCREEN
8
Press MENU.
● Using the Confirmation screen, you can skip or add
channel positions, enter station names and perform
other operations. Refer to pages 40 – 44 for the
procedures.
● Depending on reception conditions, the stations may
not be stored in order, and the station names may not
be stored correctly.
● For information on scrambled broadcasts, refer to
page 41.
IMPORTANT
● In certain reception conditions, station names may not be
stored correctly, and auto Guide Program Number Set may
not work properly. If the Guide Program numbers are not set
properly, when you timer-record a TV programme using
S
HOW V IEW , the recorder will record a TV programme of a
different station. When programming the timer using
S
HOW V IEW , be sure to check whether the channel position
on which your recorder receives the broadcasting station
you wish to record is selected (
੬
pg. 20, "S HOW V IEW Timer
Programming").
● Your video recorder memorizes all detected stations even if
reception of some of them is poor. In these cases picture
quality may be poor. To delete those stations with an
unacceptable picture
੬
"Delete A Channel" on page 41.
NOTES:
● Fine tuning is performed automatically during Auto Channel
Set. If you want to perform it manually, refer to page 44.
● If you perform Auto Channel Set when the aerial cable is not
connected properly, "SCAN COMPLETED -NO SIGNAL-"
appears on the screen in step 7. When this happens, make
sure of the aerial connection and press OK; Auto Channel Set
will take place again.
– –:– –
1 2 3
4 5 6
7 8 9
0
2
4
1
3
C: Cable
0 + + +
End Beginning
OK
MENU
%%
AUTO SET
PLEASE WAIT
[MENU] : EXIT
PR CH ID PR CH ID
01 25 ARD 08 C26 E-SP
02 C08 SKY1 09 55 WEST
03 10 ZDF 10 C24 SAT1
04 C65 RAI1 11 C23 OSF
05 C31 BBC1 12 – –␣ – –
06 C32 BBC2 13 – –␣ – –
07 C33 3SAT 14 – –␣ – –
[ 5∞ ]
= : EDIT
= [X] : DELETE
[MENU] : EXIT
∞ ∞