JVC HR-DVS2U - Manual (Page 59)

EN
59
START DUBBING
6
Engage the audio component's Play mode, then press
PLAY to start the tape in your VCR. Audio dubbing
begins at this point.
● When monitoring the audio-dubbed sound on the DV
deck, set "12BIT MODE" to "SOUND2". (
੬
pg. 33)
● blinks and is displayed on the front display
panel.
● To stop dubbing temporarily, press PAUSE. Press
PLAY to resume dubbing.
END AUDIO DUBBING
7
Press STOP to stop the tape in your VCR, and engage
the audio component's Stop mode.
NOTES:
● Once the Audio Dubbing starts, you can not use the other
deck.
● When monitoring the sound during Audio Dubbing, the
normal soundtrack is automatically selected. If you wish to
hear the Hi-Fi or mixed sound (Hi-Fi + Normal soundtracks),
refer to the "Select The Soundtrack" section (
੬
pg. 32) and
select the soundtrack you wish to hear. (VHS deck only)
● Audio dubbing stops automatically when the counter reaches
"0:00:00", and the VCR enters the Play mode. Check the
counter reading before dubbing. (VHS deck only)
● Audio dubbing is also possible using the rear AUDIO IN
connectors.
● Audio dubbing cannot be performed on a VHS/S-VHS
cassette that has had its record safety tab removed, or on a
Mini DV cassette that has had its erase protection switch set
to "SAVE".
● When playing back an audio-dubbed tape on the VHS deck,
refer to the "Select The Soundtrack" section (
੬
pg. 32) to
select the soundtrack you wish to hear. When playing back an
audio-dubbed Mini DV tape on the DV deck, set "12BIT
MODE" to "SOUND2" (
੬
pg. 33).
● Picture may be distorted during Audio Dubbing Pause.
● It may be unlawful to record or play back copyrighted
material without the consent of the copyright owner.
● Audio dubbing is not possible using the DV IN/OUT
connector.
1 2 3
4 5 6
7 8 9
0
2
4
1
3
T W
DV S-VHS
PLAY
PLAY
PAUSE
PAUSE
STOP
STOP