Jabra BT2046 - Manual (Page 10)

9
ENGLISH
JABRA BT2046
If you are on a call and receive a second call you will be alerted by
a tone . You can then:
- Put the first call on hold and accept the incoming call by press-
ing the Answer/end button
- Switch between the two active calls by pressing the Answer/
end button again
- Tap the Answer/end button once to end the first call and ac-
cept the new incoming call
TROUBLESHOOTING & FAQ
I hear crackling noises
- For the best audio quality, always wear your headset on the
same side of the body as your mobile phone .
I cannot hear anything in my headset
- Increase the volume on your phone .
- Ensure that the headset is paired with the phone .
- Make sure that the phone is connected to the headset – if it
does not connect either from the phone’s menu or by tapping
the answer/end button, follow the pairing procedure (refer to
pairing section in this user manual) .
- You can determine whether your headset is connected to a
device by looking at the flashes on the headset after tapping
the answer/end button when the headset is on very slow
single flashes means that the headset is connected to a device,
slow triple flashes means that the headset is currently not
connected .
I have connection problems
- You may have deleted your headset pairing connection in your
mobile phone . Follow the pairing instructions (refer to the
section in this user manual) .
- You can determine whether your headset is connected to a
device by looking at the flashes on the headset after tapping
the answer/end button when the headset is on very slow
single flashes means that the headset is connected to a device,
slow triple flashes means that the headset is currently not
connected .