Operation – John Deere AC-G4010S User Manual

Page 17

Advertising
background image

Operator’s Manual

17

OPERATION

Recoil Start
NOTE:
Read Operator’s Manual carefully before operating this

unit. Always make sure the unit is level and properly

grounded. Check engine oil before starting.

1. Open fuel valve on fuel tank. (See Fig. 3)
2. Move choke lever to full choke. If re-starting a warm

engine, the choke should be left in the off position. (See

Fig. 4)

3. Turn the engine ignition switch to the ON position.
4. Pull recoil to start engine.
5. Once engine has started, slowly move choke lever to no

choke.

NOTE: When engine fails to start after several attempts, repeat

the starting procedures mentioned above with the choke

lever in the off position.

6. Allow the unit to run for two (2) minute warm-up.
7. Make sure the generator is grounded. See Preparing the

Generator; Grounding Instructions.

8. Test the GFCI receptacle(s) on the unit. Push the test button.

The reset button should pop out and there should be no

power at the receptacle. Apply a test load or lamp to each

receptacle to verify. IF THE RESET BUTTON DOES NOT

POP OUT, DO NOT USE THE RECEPTACLES(S). SEE

DEALER FOR SERVICE IMMEDIATELY.

9. If GFCI receptacle(s) test correctly, firmly push the reset

button to restore power. A distinctive click should be

heard or felt when this is complete. IF THE

RECEPTACLE(S) DO NOT RESET PROPERLY, DO

NOT USE THE RECEPTACLE(S). SEE DEALER FOR

SERVICE IMMEDIATELY.

10. Loads can now be applied to the unit.
11. If unit is equipped with a Full Power Switch, move the

Full Power Switch to the 120V position to direct all power

to the 120V/30A receptacle on the unit. This

will disable all other receptacles.

When the Full Power Switch is in the 120V/240V

position, all receptacles are usable except the 120V/30A

receptacle.

NOTE: This engine is equipped with a “Low Oil” shutdown

system for engine protection. The engine stops when

the oil level gets too low. The engine will not restart

without adding oil. Refer to Preparing the Generator;

Engine Fuel Capacity for instructions on adding oil.

Operation

(Fig. 4)

(Subaru Shown)

(Fig. 3)

Advertising
This manual is related to the following products: