JVC VM-4200 - Manual (Page 15)

13
Connecting an external control unit
When connecting the external control unit to the MAKE terminal, you can operate the following functions through the
MAKE terminal;
• Turn on or off the Monitor.
Preparation: The POWER switch on the rear must be set to “| (on)” (so that the Monitor is in standby mode).
• Select the input.
Preparation: “REMOTE SWITCH” should be set correctly to select your desired input (see page 27).
Notes:
• There is no remote control on/off switch. When a plug is inserted to the MAKE terminal, remote control through the
external control unit is automatically activated.
• When the other REMOTE terminals are used at the same time, transmitted commands through the MAKE terminal have
priority over those through the other terminals.
IMPORTANT:
External control unit is not commercially available in the market. When you need it, consult your dealer.
• MAKE terminal • External control unit
Pin number Signal name
1 GND
2 GND
3 SW2
4 SW1
5 SW DET
6 GND
Signals
transmitted
=
○ ○ ○ ○
=
○ ○ ○ ○
=
○ ○ ○ ○
TTL level
H: Power Off L: Power On
H: Input A* L: Input B*
H: Not connected L: Connected
* Input A and Input B will be determined by the “REMOTE
SWITCH” setting.
1 2
3 4
6 5
04-13_VM-4200.p65 03.7.23, 9:29 AM 13