Sabrent Computer Drive - Manual

Sabrent SBT‐UFDB 1.44MB EXTERNAL USB FLOPPY DISK DRIVE
Device Setup
1. Insert the USB Cable from your SBT‐UFDB into an available USB port on your computer. Make certain there is no
floppy disk in the disk drive during installation.
1. You will receive a prompt informing you that Windows is “Installing device driver software”:
Figure A:
2. You can proceed directly to Step 6 to begin using the Sabrent USB Floppy Drive. However, if you wish to first
confirm that the installation is fully complete, press the Start Button and right‐click on Computer and click on
Manage: