Sharp IQ-8900 - Manual (Page 250)

2. Open the cover of the cable jack on each unit.
3. Plug one end of the cable into the cable jack on each unit.
4. Turn on both units.
Press and touch
5. Select GLOBAL SETTINGS and SET UNIT TO UNIT
PATH.
6. Select VIA DIRECT CABLE.
l
To conserve battery power, disconnect the cable as
soon as a transfer is completed.
l
and do not work in cable transfers. You
must use the PERIPHERALS menu to transfer data by
cable. Pressing these keys always initiates infrared
transfer regardless of the selection for SET UNIT TO
UNIT PATH or of whether the cable is connected or not.
7. Transfer data following the same menu procedures as for
the transfer shown on pages 246 to 248.
Receiving
data from
units
other than
To connect the two units, you need the optional CE-315L
cable.
Initial set-up
the 89001
1. Turn off both units.
9000
Series
2. Open the cover of the cable jack on each unit.
3. Plug one end of the cable into the cable jack on each unit.
To conserve battery power, disconnect the cable as soon
as a transfer is completed.
249