Sentry Industries Sentry 2.0 - Manual (Page 32)

32
Sentry Cone-Fire Shorthand Programming
After you press the key(s) in the left column, the message to the right will appear. Press 1from IdLE . If the 1key does not re-
spond, your controller does not have Cone-Fire.
KEYS TO PRESS DISPLAY COMMENTS
Apply power to kiln IdLE Press Enter if IdLE doesn’t appear.
1 CONE Enter the cone number .
Cone # (i.e. 05) 05
ENTER SPd Enter the firing speed.
1(Fast), 2 (Med.), or 3 (Slow) FAST The firing speed appears.
ENTER PRHT Enter Pre-heat time.
Pre-Heat time (0 if none) 00.00 Pre-heat time appears.
ENTER HOLD Enter hold time.
Hold time (0 if none) 00.00 Hold time appears.
ENTER COOL Enter slow cooling rate.
Slow cooling rate (0 if none) 0000 Shows degrees per hour.
ENTER IdLE Kiln is ready to fire.
ENTER STRT Kiln is now firing. Press 6 for
Program Review.
The Kiln is now firing to the cone you selected.
Appendix F: