Sharp FP-P60CX - Manual (Page 11)

ENGLISH
FRANÇAIS
ESPAÑOL
E-9
OPERATION
Insert batteries
Insert batteries with and as
shown below.
REMOTE CONTROL USE
• Operate the remote control facing the main unit
receiver.
• The signal range is about 23 feet (7m).
• Make sure there are no objects blocking the
path of the signal.
• A beep sound will be heard from the main unit
when a signal is received.
NOTE
• Avoid dropping or damaging the remote
control, using in a high humidity condition, in
direct sunlight or near a heat source.
Receiver
Transmitter
PREPARATION
INSERTING BATTERIES IN THE REMOTE CONTROL
1
2
3
Remove the back cover
Press and slide the back cover to
remove.
Close the back cover
Battery Information
• The battery life is about 1 year.
• The batteries for this remote control are for initial use only . Change the batteries
when necessary.
• Incorrect usage of the batteries may cause battery fluid leakage and/or damage.
Take care of the following when handling:
• When replacing the batteries, replace both batteries with new ones of the same
type. (Use 2 AA manganese batteries.)
• When not using the unit or remote control for an extended period, remove the
batteries.