SIGMA DE2-70 - Manual (Page 34)

DE2-70 User Manual
31
Configuring the FPGA in JTAG Mode
Figure 5.1 illustrates the JTAG configuration setup. To download a configuration bit stream into the
Cyclone II FPGA, perform the following steps:
• Ensure that power is applied to the DE2-70 board
• Connect the supplied USB cable to the USB Blaster port on the DE2-70 board (see Figure
2.1)
• Configure the JTAG programming circuit by setting the RUN/PROG switch (on the left side
of the board) to the RUN position.
• The FPGA can now be programmed by using the Quartus II Programmer module to select a
configuration bit stream file with the .sof filename extension
FPGA
USB Blaster Circuit
EPCS16
Serial
Configuration
Device
JTAG Config Port
USB JTAG Config Signals
Auto
Power-on Config
MAX
3128
Quartus II
Programmer JTAG UART
PROG/RUN
"RUN"
Figure 5.1. The JTAG configuration scheme.
Configuring the EPCS16 in AS Mode
Figure 5.2 illustrates the AS configuration set up. To download a configuration bit stream into the
EPCS16 serial EEPROM device, perform the following steps:
• Ensure that power is applied to the DE2-70 board
• Connect the supplied USB cable to the USB Blaster port on the DE2-70 board (see Figure
2.1)
• Configure the JTAG programming circuit by setting the RUN/PROG switch (on the left side
of the board) to the PROG position.
• The EPCS16 chip can now be programmed by using the Quartus II Programmer module to
select a configuration bit stream file with the .pof filename extension
• Once the programming operation is finished, set the RUN/PROG switch back to the RUN