Sterling SXS Series - Manual (Page 26)

BJ5-620 Installation 26 of 73
9 Switch ON machine for a short period of time and check rotational direction. The
rotational direction can be seen at the discharge air fan of the drive motor (observe
running direction arrow).
9 Switch ON hydraulic unit for a short time and check rotational direction.
9 Allow machine to run for approximately 10 minutes without shredding material.
9 Connect material discharge device and in-feed device; check rotational direction
drives.
9 Feed grinding material uniformly. Too much material can lead to overload of the
machine.
9 Check the temperature of the ground material if necessary.
9 Monitor the ammeter. This displays the present current consumption and gives
information on the load of the machine.