Sanyo PLC-XE33 - Manual (Page 4)

PLC-XE33 Basic Serial Command Specifications
3/22
1. Overview
1.1. These specifications define projector control commands for PLC-XE33.
1.2. The projector control commands are used to remotely control a projector through RS-232C from a
computer.
2. Serial Interface Specifications
2.1. Transfer Specifications
Item Specifications
Synchronous system Asynchronous
Transmission Speed 9600 / 19200
Data Length 8 bit
Parity N/A
Stop Bit 1
Flow Control N/A
1) Transmission speed: initial setting value is 19200.
2) Transmission speed can be changed in service mode.
2.2. Connection
Dedicated serial cable must be used for connection to a computer and a projector.
PC Projector
COM 1 Control Port
D-Sub 9 Pin D-Sub 9 Pin