Sharp CD G14000 - Manual (Page 30)

08/1/15 CD-G14000_EN.fm
30
Radio
TINSEA128AWZZ
CD-G14000
Listening to the radio
Auto power on function:
When you press any of the following buttons, the unit turns on.
TUNER (BAND) button (main unit and remote control): The unit
turns on and the “TUNER” function is activated.
/ button on the main unit: The unit turns on and playback of
the last function starts (CD, TAPE, TUNER, AUDIO IN).
Tuning
Notes:
When radio interference occurs, auto scan tuning may stop
automatically at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING ( or ) button
again.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the “ST” indicator.
“ ” will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER (BAND) button to
extinguish the “ST” indicator. The reception changes to monaural,
and the sound becomes clearer.
TIMER
POWER ON/ STAND-BY
CD
TUNER
(BAND)
4 3
1
5
4
5
3
2
1
PRESET
TUNING
PRESET
TUNING VOL. VOL.
PHONES AUDIO IN
RECORD/PLAYBACK PLAYBACK (PLAY & S TOP)
REMOTE
SENSOR
2
TAPE (1 2)
OPEN/
CLOSE c
AUDIO IN
TUNER
(BAND)
POWER
ON/ STAND-BY
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER (BAND) button repeatedly to select the
desired frequency band (FM or AM).
3 Press the TUNING ( or ) button to tune in to the desired
station.
Manual tuning:
Press the TUNING ( or ) button as many times as required
to tune in to the desired station.
Auto tuning:
When the TUNING ( or ) button is pressed for more than 0.5
seconds, scanning will start automatically and the tuner will
stop at the first receivable broadcast station.
FM stereo mode indicator
FM stereo receiving indicator