Sharp AR-M257 - Manual (Page 43)

17
BEFORE USING THE MACHINE
1
LOADING PAPER
Make sure that the machine is not copying, printing, or printing a received fax, and then follow these steps to load paper.
Loading the paper in the paper tray
1 Pull out the paper tray until it stops.
If you are loading the
same size of paper as
was loaded previously,
go to step 4. If you are
loading a different size of
paper, continue with the
following step.
2 Squeeze the lock lever of the front
guide and slide the front guide to
match the width of the paper.
3 Move the left guide to the appropriate
slot as marked on the tray.
When using 11" x 17"
copy paper, store the left
guide in the slot at the left
front of the paper tray.
4 Fan the copy paper.
5 Load paper in the tray.
6 Push the paper tray firmly back into
the machine.
If you loaded a different size of paper that was loaded
previously, place the appropriate paper size card in the
front of the paper tray to indicate the new paper size.
Front guide
Left guide
• Load the paper with the print side facing up.
• Insert the paper along the guides.
• The tray holds up to 500 sheets of 21 lb.
(80g/m 2 ) bond paper.
• Do not load paper above the maximum
height line.
• When adding paper, first remove any
paper remaining in the tray, combine it
with the paper to be added, and then
reload as a single stack.
If you loaded a different size of paper that
was loaded previously, go to "CHANGING A
TRAY’S PAPER TYPE AND PAPER SIZE
SETTINGS" (p.19).
Maximum height line
Note
Paper size card
Note
!Andromeda_copy_sec.book 17 ページ ２００６年１１月２３日 木曜日 午後６時１分