Senatek HELLODEVICE LITE SERIES LS100 - Manual (Page 10)

10
2: Getting Started
This chapter describes how to set up and configure the LS100 in the first place.
- 2.1 Panel Layout explains the panel layout and LED indicators.
- 2.2 Connecting the Hardware describes how to connect the power, the network, and the serial
device to the LS100.
- 2.3 Accessing Console Port describes how to access the console port using a serial console at a
local site or telnet console at a remote site.
- 2.4 Command Usages described how to use command set of the LS100 to configure and view
parameter values and status.
Following items are pre-required to get started.
- One DC power adapter (included in the package).
- One serial console cable for configuration (included in the package).
- One RS-232 serial cable for connecting the RS-232 serial device.
- One PC with Network Interface Card (hereafter, NIC) and/or one RS232 serial port.
- Terminal emulation program running on the PC
- One Ethernet cable
2.1 Panel Layout
The LS100 has five LED indicator lamps for status display. Two lamps on the upper side indicate
statuses of 10 Base-T Ethernet Link and Act. Next lamp indicates statuses of receive and transmit of
the serial port for data communication. Next two lamps indicate the system running status and the
system power-on status. Table 2-1 describes function of each LED indicator lamp.
Table 2-1. LED indicator lamps
Lamps Function
Link Turned on to Green if connected to 10 Base-T Ethernet network 10 Base-T
Act Blink whenever there is any activities such as incoming or outgoing packets
through the LS100 Ethernet port
Serial port Rx/Tx Blink whenever there is any incoming or outgoing data stream through the
serial port of the LS100
Ready Turned on to GREEN if system is running. Status
Power Turned on to RED if power is supplied