Shure PGXD - Manual (Page 10)

4
channel
Single System Setup
Scan
Use the scan feature on the receiver to
find a clear channel.
LED screen displays
current channel
press channel
button to scan for a
clear channel
system scans for the channel
with the least interference
Synchronize
Synchronize the transmitter to the receiver by aligning the
infrared (IR) ports and pressing the sync button. Make sure
the IR ports are closely aligned.
After a successful sync, the transmitter LED momentarily
flashes red and the receiver ready light illuminates.
Multiple System Setup
NOTE: This wireless system may be affected by RF inter-
ference when used in proximity to other wireless devices
such as cordless phones, baby monitors, and two-way ra-
dios. For best results, use the scan and sync feature before
each use or if you experience problems.
Use the following steps to ensure the best performance when installing multiple wire-
less systems at the same location.
1. Turn all receivers on and all transmitters off.
Note: Turn on any other digital equipment that could cause interference during
the performance so it will be detected during the frequency scans in the following
steps.
2. Make sure the group number is the same for all receivers (see Manual Group
Selection).
3. Perform a scan using the first receiver.
4. Turn on the first transmitter and sync it to the receiver.
5. Repeat for each system.
• Important: After syncing each transmitter, leave it on so that scans from the other
receivers will not select that channel.
• Be sure only one transmitter IR port is exposed when synchronizing each system.
Compatible Frequencies
When operating multiple systems simultaneously, choose one group from the following
table and set all systems to different channels within that group.
Number of
Systems
Group (by band)
X8
X8A
(Austrailia)
X8B (Brazil)
2 3 to 9 3 to 9 3 to 9
3 3 to 9 3 to 9 3 to 9
4 3 to 9 -- 3 to 9
5 7 to 9 -- --