Scag Power Equipment MAG - Manual (Page 61)

74
GREASE FITTING LUBRICATION CHART
LUBRICATION NO. OF
LOCATION INTERVAL LUBRICANT PLACES
1. Cutter Drive Spindle 40 Hours/Weekly +Lithium MP White Grease 2125 1
2. Cutter Deck Spindles 40 Hours/Weekly +Lithium MP White Grease 2125 3
3. Caster Wheel Bearing 100 Hours/Bi-Monthly Chassis Grease 2
4. Caster Wheel Pivot 100 Hours/Bi-Monthly Chassis Grease 2
5. Electric Clutch Belt Idler Arm 100 Hours/Bi-Monthly Chassis Grease 1
6. Cutter Drive Shaft 100 Hours/Bi-Monthly Chassis Grease 3
7. Cutter Belt Idler Arms 100 Hours/Bi-Monthly Chassis Grease 2
8. Deck Support Pivot 100 Hours/Bi-Monthly Chassis Grease 2
9. Deck Push Arms 100 Hours/ Bi-Monthly Chassis Grease 2
10. Deck Lift Bellcranks 100 Hours/Bi-Monthly Chassis Grease 4
11. Pump Idler Arm 100 HoursBi-Monthly Chassis Grease 1
12. Rear Wheel Pivot 200 Hours/Monthly Chassis Grease 1
13. Rear Wheel Bearings 200 Hours/Monthly +Lithium MP White Grease 2125 1
14. Right Hand Foot Plate Pivot 200 Hours/Monthly Chassis Grease 1
15. Steering Handle 200 Hours/Monthly Chassis Grease 1
16. Throttle Lever 200 Hours/Monthly Chassis Grease 1
17. Parking Brake Lever 200 Hours/Monthly Chassis Grease 1
18. Blade Brake Linkage Lever 200 Hours/Monthly Chassis Grease 1
19. Blade Brake Linkage Bellcrank 200 Hours/Monthly Chassis Grease 1
20. Blade Brake Control Lever 200 Hours/Monthly Chassis Grease 1
* Lubrication may be required every 8 to 40 hours, depending on climate and environment. Apply two
pumps of hand gun when lubricating these locations. DO NOT over-grease; damage to seal may
occur.
+ Compatible Greases: Mobilix #2 found at Mobil Service Station
Ronex MP found at Exxon Service Stations
Super Lube MEP #2 & Super Stay-M #2 found at Conoco Stations
Lidok EP #2 found at industrial shops