Sun Microsystems Gigabit Ethernet MMF/UTP Adapter User Manual
Page 108
74
Sun PCI-Express Dual Gigabit Ethernet MMF/UTP Adapter Installation and User’s Guide • June 2006
7. Use the test command and the device paths found in
to test the adapter
when you use the FCode self-test.
The structure of the test command line includes the following device parameters:
where:
s = 1000, 100, 10, auto
d = half, full, auto
c = master, slave, auto
Note –
The speed, duplex, and link-clock parameters are optional tests.
The following default tests are run when you execute the test command:
■
Tests six groups of Ophir registers (You can see the names of the six groups in the
output sample shown on the following page.)
■
Internal loopback test for the UTP card and external loopback test for the MMF
card.
■
10 Mbps PHY loopback.
Refer to the appropriate OpenBoot Command Reference Manual for more information
about the test command.
ok test
device-path:speed=s,duplex=d,link-clock=c,promiscuous,