Sharp MD-MT16H - Manual (Page 15)

MIC SYNC H
MIC SYNC L
–24dB
–12dB
14
RECORDING FROM THE MICROPHONE
■ Recording from the microphone
(Mic synchro recording)
The recording will begin automatically in
response to a noise or a person speaking.
When the sound stops, the recording will
pause. This function is convenient when
recording lectures, conferences, etc.
1
Connect the stereo microphone to the
MIC IN socket.
● When a microphone is connected to
this unit, the unit will automatically
switch to input from the microphone.
2
Insert a recordable MiniDisc.
(See page 11.)
● Adjust the recording level so that
the maximum sound volume from
the source makes the reading swing
between –4 dB and 0 dB.
● When the recording level display is
changed from “MIC H 21” to “MIC L
20”, the sound will be interrupted
momentarily.
This is normal.
5
Press the ENTER/SYNC button to
select the synchro recording level.
(This level can be changed, even
whilst recording.)
● Refer to the following table.
● When the microphone input is set to
“MIC SYNC H”, recording will start
when the smallest noise is detected.
If the unit starts recording too often
from small unwanted noises, set the
microphone input to “MIC SYNC L”.
MIC IN
PLUG IN
POWER
To the MIC
IN socket
Stereo microphone
(commercially available)
Mic input
Synchro
recording level
display
Sound level at which
to start recording
0dB
–4dB
3
Press the REC button.
● A monaural, long-play recording mode
is available. (Page 18)
● Timed identification marks can be
created whilst recording. (Page 16)
4
Press the
5
or
4
button to adjust
the recording level.
Continued to the next page.
* MD-MT16H FOR UK(01-21) 99.4.2, 0:57 PM 15