Sharp MD-MT20H - Manual (Page 41)

40
● The battery run down.
● Nothing is recorded.
● No copy can be made because of
the SCMS copyright system.
● A track cannot be edited.
● Recording cannot be performed cor-
rectly due to vibration or shock in the unit.
● Editing is impossible.
● The disc is scratched.
● Poor connection of the digital cable.
● The disc is out of recording space.
● The unit is in the hold mode.
● The OPEN lever was moved during
recording or editing.
● A disc has not been loaded.
● You tried to record on a playback-
only disc.
● Improper power is being supplied.
● The MD is write protected.
● The disc is damaged.
● Since a track number is currently
being located or written to, the unit
cannot accept your command.
● You have come to the conclusion
that the unit is out of order.
● The temperature is too high.
● A large portion of the disc has been
damaged.
● There is no space left for recording
character information (track names,
disc names, etc.).
● The track has been protected from
being erased.
● A large portion of the disc has been
damaged.
● There is an error in the recorded sig-
nal.
● A disc which contains data other than
music was played.
● There is an error in the signal from
the disc.
● Charge the rechargeable battery or
replace the alkaline batteries (or use
the AC adaptor for power).
● Replace the disc with a recorded disc.
● Record using the analogue cable.
● Change the stop position of the track
and then try editing it.
● Re-record or replace it with another
recordable disc.
● Check the number of tracks.
● If the sound you hear is not right, try
recording again.
● Replace the disc with another re-
cordable disc.
● Connect the digital cable securely.
● Replace it with another recordable
disc.
● Return the HOLD switch to its origi-
nal position.
● Turn off the power and remove the
MiniDisc.
● Load a disc.
● Replace it with a recordable disc.
● Use one of the specified power
sources.
● Move the write protection knob back
to its original position.
● Reload the disc or replace it.
● Replace it with another recorded disc.
● Wait for a while and try the opera-
tion again.
● To have it repaired, go to the distribu-
tor where you purchased the unit.
● Turn off the power, and wait for a
while.
● Replace it with another recorded
disc.
● Replace it with another recordable
disc.
● Edit the track with the device on
which it was recorded.
● Replace it with another recorded
disc.
● Erase all of the signal errors, and
then try recording again.
● A disc which contains non-music
data cannot be played.
● Replace it with another recorded
disc.
ERROR MESSAGES
Error messages Remedy
BATT EMPTY
BLANK DISC
Can’t COPY
Can’t EDIT
Can’t REC
Can’t WRITE
DEFECT
Din UNLOCK
READ ERROR
DISC FULL
HOLD
LOCKED
LOCK ERROR
NO DISC
PB DISC
POWER ?
SORRY
SYSTEM ERR
TEMP OVER
TOC ERROR
TOC FULL
Tr. Protect
U TOC ERROR
? DISC
Meaning
PROTECTED
* MD-MT20H FOR UK(22-42) 99.3.11, 2:30 PM 41