Sharp YO-P20hII User Manual

Page 32

Advertising
background image

30

0 . 1 2 3 4 5 6 7 8 9
0 . 1 2 3 4 5 6 7 8 9
0 . 1 2 3 4 5 6 7 8 9
0 . 1 2 3 4 5 6 7 8 9
0 . 1 2 3 4 5 6 7 8 9
0 . 1 2 3 4 5 6 7 8 9
0 . 1 2 3 4 5 6 7 8 9

Declaration of Conformity
Electronic Organizer : YO-P20H

II

This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

Responsible Party:

SHARP ELECTRONICS CORPORATION
Sharp Plaza, Mahwah, New Jersey 07430-1163
TEL: 1-800-BE-SHARP

Tested To Comply With FCC Standards

FOR HOME OR OFFICE USE

WARNING – FCC Regulations state that any unauthorized changes or
modifications to this equipment not expressly approved by the
manufacturer could void the user's authority to operate this equipment.

Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.

Note: A shielded interface cable is required to ensure compliance with

FCC regulations for Class B certification.

YO-P20HII(En).pm65

05.2.2, 4:47 PM

30

Advertising