Swisher ZT2560 - Manual (Page 21)

SERVICE & ADJUSTMENTS
Push out on the Deck Lift Handle and raise or lower the deck to the desired
position.
Position 1 is the lowest setting and Position 8 is the highest position
The cutting range is from approximately 1 ½” to approximately 5”
Adjusting The Cutting Height
TOOLS REQUIRED:
2 - ½” Wrenches or ½” Socket with drive ratchet
Lower the cutting deck down to the lowest position (position 1)
Loosen the nuts on the top side of the deck hanger brackets (3 places) where the
lift cables attach to.
With all three loose on top of the brackets the deck should now set on the ground
resting on the roller wheels.
Tighten the nuts on the top of the lift brackets making sure that all three lift cables
are pulled tight.
Lift deck using the deck lift handle to the desired position
Deck Leveling
21 21