Schumacher SE-4022 User Manual

Page 13

Advertising
background image

9

CONTROL PANEL

10.

Note: Not all controls are available on all models.
Charge Rate Selector Switch

Use the Charge Rate selector switch to select the charge rate or engine

starting setting you require.

2A Slow Charge Rate

– Intended for charging small batteries such as

those commonly used in garden tractors, snow mobiles and motorcycles.
10A, 15A, 20A, 30A Fast and 35A, 40A, 44A, 50A, 60A, 80A Rapid

Charge Rate – Use for charging automotive, marine and deep-cycle

batteries. Not intended for industrial applications.
100A, 125A, 180A, 200A, 225A, 300A Engine Start

– Provides

100, 125,

180, 200, 225 or 300 amps for cranking an engine with a weak or run down

battery. Always use in combination with a battery.

Timer (Not applicable for model SE-2352)

Timer Setting

: The timer allows you to set a specified time for charging.

After the timer expires, the charger stops charging your battery. The main

function of the timer is to prevent over charging while allowing a battery

time to obtain a satisfactory charge. To properly set the timer, you must

know the size of the battery in ampere hours or reserve capacity in minutes

and the state of charge. It is important that you determine the appropriate

state of charge of your battery as specified in Section 12 and set the timer

accordingly.
Hold

: This position defeats the timer function, allowing for continuous

operation. Be sure to monitor the charging progress and stop it when the

battery is charged. Not doing so may cause damage to your battery or may

cause other personal property damage or personal injury.

Ammeter

The Ammeter indicates the amount of current, measured in amps, that is being

drawn by the battery. As a battery takes on a charge, it draws less current from

the charger. Correspondingly, the meter will show less current being drawn by

the battery. When the current stops decreasing, the battery is charged. The

start area of the meter indicates a high rate of current being drawn from the

charger. When cranking an engine, the meter needle will be at the extreme

right side of the start area. The 2 amp charge rate may indicate some activity

on the meter, although the meter does not have the resolution to display this

low rate.

Percent of Charge

The percent of charge scale is intended as a visual aid to help simplify

reading the state of charge. The percent of charge is based on the current

drawn by the battery. For this reason, accuracy will vary with the size and

battery type. This means that the indication for a fully charged large battery

may be slightly less than 100%.

Model SE-2352 employs 2 toggle switches:

Switch #1

- Use this switch to select the 200 Amp Engine Start and the 35

Amp Charge Rate. Switch #2 must be in the down position (Select Position)

when using Switch #1.
Switch #2 - Use this switch to select the 2 amp Charge Rate and the OFF

position. Also, use to select use of Switch #1. Note that Switch #1 is only

effective when Switch #2 is set to “Select Position.”

Battery Load Tester Switch (Model SE-8050 only)

When testing a battery, use this switch to apply a load to it.

Advertising
This manual is related to the following products: