Shindaiwa Multipurpose Pole Pruner Attachment 78701 T230 - Manual (Page 9)

9
Adjusting the Throttle Cable
1. Loosen the two 10mm throttle cable nuts at the fan cover as shown in Figure 16.
Idle Throttle
Position
1/4-inch Throttle
Freeplay
Full
Throttle
Position
Stop on
throttle
body
3. When 1/4-inch of free play is achieved, securely tighten the two 10mm throttle
cable nuts. When the throttle cable is correctly adjusted, and the throttle trigger
is fully depressed (full throttle), the throttle will contact the stop on the throttle
body. See Figure 18.
NOTE:
Apply Never-Seez™ or equivalent on the cylinder cover knob threads for easier
removal.
4. Replace the cylinder cover.
5. Replace the spark plug boot.
Cable Adjuster Nuts
Figure 16
Figure 17
Figure 18
IMPORTANT!
Make sure the stop switch wires do not interfere with throttle functions.
Reposition wires if necessary.
2. Adjust the throttle cable adjuster nuts until you achieve a free play on the throttle
trigger of about 1/4 inch. See Figure 17.